声测管堵管处理方法：

1、对于既定的检测方案原则上不得更改。

2、“通管”：当声测管堵塞时，施工单位应采取有效措施进行“通管”，可采用下述3种方法：

①用粗长钢筋捅通测管；

②用高压水冲洗清管；

③采用钻机配小钻头进行扫孔。

3、当无法“通管”时，按以下原则处理：

①、当为某桥的第一根桩时，必须进行抽芯检测。

②、当为某桥的非第一根桩时，施工单位按附表1的格式填写《变更检测方法申请表》，并经监理、业主代表和监督负责人签名同意后，予以实施。

③、若某桥多次出现堵管问题，须适时进行抽芯检测。

4、增加的检测费用由施工单位承担。

5、监理须要求施工单位在申报检测前对声测管进行检查；当需更改检测方案时，提前完善相关手续，避免因声测管检测问题影响施工的顺利推进。

1, to established detection scheme in principle cannot be changed.
2, "pipe" : when this tube jam, a construction unit should take effective measures to "pipe", can adopt the following three methods:
(1) with tong tong long steel tube measurement;
(2) with high pressure water washing pigging;
(3) the drill hole scanning with little bit.
3, when unable to "pipe", according to the following principles:
(1), when the first root pile for a certain bridge, core pulling test must be conducted.
(2), when the first root pile for a certain bridge, the construction unit according to the attached format to fill out the application form for change detection method, and with the approval of the supervision, owner representative and supervision, head of the signature, after.
(3) many times, if a bridge plugging pipe problem, must be timely detection of core pulling.
4, increase the test fee shall be borne by the construction unit.
5, supervision of the construction unit should be asked before filing test inspection on acoustic detecting tube; When need to change the detection scheme, perfect the relevant formalities in advance, to avoid detection problem of acoustic detection affect construction smoothly.
1, to established detection scheme in principle cannot be changed.
2, "pipe" : when this tube jam, a construction unit should take effective measures to "pipe", can adopt the following three methods:
(1) with tong tong long steel tube measurement;
(2) with high pressure water washing pigging;
(3) the drill hole scanning with little bit.
3, when unable to "pipe", according to the following principles:
(1), when the first root pile for a certain bridge, core pulling test must be conducted.
(2), when the first root pile for a certain bridge, the construction unit according to the attached format to fill out the application form for change detection method, and with the approval of the supervision, owner representative and supervision, head of the signature, after.
(3) many times, if a bridge plugging pipe problem, must be timely detection of core pulling.
4, increase the test fee shall be borne by the construction unit.
5, supervision of the construction unit should be asked before filing test inspection on acoustic detecting tube; When need to change the detection scheme, perfect the relevant formalities in advance, to avoid detection problem of acoustic detection affect construction smoothly.